Pneumatic & Hydraulic Hose Assembly

Our BSI ISO 9001:2015 and Q-Mark BFPA approved on-site hose assembly facility features a trained and certified team of engineers, who can build and test a wide range of hydraulic and pneumatic hose assemblies.

Hydraulic Hose Assemblies

• Assemble smooth bore, convoluted PTFE Lines & S/S overbraided hose assemblies up to 1"
• ½” twin breaker assemblies to catalogued lengths
• Up to 1" 1SN, 2SN & 4SP hose assemblies
• Shrink wrapped, marked, engraved or labelled as required
• Bespoke variants are available to customer specifications
• Pressure tested up to 10,000 psi hydrostatically

Pneumatic Hose Assemblies

• Wide range of low-pressure hose assembly options including braided rubbers, PVC and polyurethanes
• Assemblies from a single line assembly with 8-jaw pallet crimped ends up to a complicated umbilical multi-line configuration
• Shrink wrapped, marked, engraved or labelled as required
• Bespoke variants are available to customer specifications

Hydraulic Hose Assembly Capabilities

We can manufacture hose assemblies on site up to 1" 1sn, 2sn and 4sp and pressure test up to 10,000psi hydrostatically, complete with 100% batch test traceability and certification if required.

We also assemble both smooth bore and convoluted PTFE lines st/st over braided hose assemblies up to 1".

We offer ½” twin “breaker assemblies” to both catalogued lengths and bespoke variants to customers specifications. These can be set as a standard part number for re-ordering.

Low Pressure/Pneumatic Hose Assembly Capabilities

Our facility covers a wide range of low-pressure hose assembly options including braided rubbers, pvc and polyurethanes. We can assemble anything from a simple single line assembly with 8 jaw pallet crimped ends up to complicated umbilical multi lines configurations. We also assemble air prep sets to customer specifications.

All pneumatic low-pressure assemblies are produced to internal standards and crimp settings have been validated through a series of in-house tests including a static pneumatic pressure test and a tensile pull test to verify the integrity of the crimp.

The pull test requirement was developed from the en139 breathing air specification and has been adopted (where possible) across all hose configurations as a minimum.

We have an in house static pneumatic pressure test capacity of up to 600psi, with 100% batch test traceability and certification if required.

We also have the capability to individually shrink wrap all hose assemblies as well as mark, engrave label as required.